FMA202 SMS events

From Wiki Knowledge Base | Teltonika GPS
Revision as of 08:49, 6 May 2019 by Airidas.S (talk | contribs)

(diff) ← Older revision | Approved revision (diff) | Latest revision (diff) | Newer revision → (diff)
Main Page > End of Life Products > FMA202 > FMA202 Configuration > FMA202 SMS events

SMS events functionality allows FMA202 to send a configured SMS when an event is triggered. This event can be triggered by:

When any of the above events is triggered, FMA202 sends a configured SMS message to a defined phone number. If SMS events is activated, but there are no numbers defined in SMS events PreDefined Numbers list (figure below), then the device will not send any messages.

FM36YX Predefined list.png

The sent SMS messages format is according to:
“Date Time EventText”

For example, if FMA202 is configured to send an SMS (figure below "SMS Events" section), when Digital Input 1 reaches High level, with priority High and configured to generate event on both range enter and exit(figure below "IO" section), then the sent SMS is:
“2016/1/20 12:00:00 Digital Input 1”

FM36YX SMS event DIN1.png

The SMS Text field can be altered and any text can be entered. Maximum message length is 90 symbols (numbers, letters and symbols in ASCII, except for comma “,”).

Bw nb.png ATTENTION! If FMA202 is in Deep Sleep mode and SMS event occurs with LOW priority (which does not wake up FMA202), then the device does not send the message. It is saved in device memory until it wakes up from Deep Sleep mode and GSM modem starts working normally. After it wakes up, all the messages that are saved in memory will be sent, but keep in mind that only 10 messages can be saved in memory – all other messages will not be saved, until there is room in device memory.



To configure SMS events for scenarios, open Scenarios window and Enable desired scenario. Then go to GSM ->SMS -> SMS events window and activate SMS event for Enabled scenario. Figure below shows how to enable Green Driving and Immobilizer SMS Events.

FM36YX SMS event Scenarios.png

When any of the scenarios events occurs, a text message will be sent to the predefined number.


In order to configure Trip SMS events click on Trip window and Enable Trip feature (figure below). Then go to GSM -> SMS -> SMS Events settings and Enable Trip SMS event. After enabling SMS Events (figure below), trip event will be triggered and message sent, when Trip starts (GNSS speed exceeds the speed in Start Speed (ex. 5 km/h) and when Trip stops, that is ignition is turned off longer then the time written in Ignition Off Timeout (ex. 60 seconds).

FM36YX SMS event TRIP.png


Geofence SMS event is triggered and message sent when the device exits and/or enters a configured Geofence zone. The Geofence zone must be configured to generate an event On Exit, On Enter or On Both (figure below). If No Event is selected, then it is not possible to turn on SMS events. If several zones are created then SMS events can be turned on separately for each zone entering different text message.

FM36YX SMS event Geofence.png


SMS events for AutoGeofence are configured the same as in Geofence. AutoGeofence is in Features -> Auto geofencing, for SMS events configuration, go to GSM -> SMS -> SMS Events (figure below).

FM36YX SMS event AutoGeofence.png

I/O events

FMA202 sends SMS event message when a configured I/O property enters and/or exits its configured High/Low boundaries or Hysteresis event generation is chosen (Monitoring does not generate event, so SMS event could not be configured). Every IO element SMS event can be configured to send individual message to different numbers.

FM36YX SMS event I-O events.png