From Wiki Knowledge Base | Teltonika GPS
|
|
| (4 intermediate revisions by 3 users not shown) |
| Line 1: |
Line 1: |
| − | [[File:800px-1_FMX640_+_DAF.png|800px|center]]
| |
| | | | |
| − | ==Installation proccess==
| |
| − |
| |
| − | * Below is shown main installation location:
| |
| − |
| |
| − | [[File:2 Fuse panel cover.png|800px|center|Fuse panel cover]]
| |
| − |
| |
| − | * Carefully unscrew the fuse panel screws and fold the panel down.
| |
| − |
| |
| − | [[File:3 Fuse panel and screws location.png|800px|center|Fuse panel and screws location]]
| |
| − |
| |
| − | * Where to find the main connector?
| |
| − |
| |
| − | [[File:4 Main FMS connector location.png|800px|center|Main FMS connector location]]
| |
| − |
| |
| − | * Connect the wires accordingly. It is recommended to use DIN 1 instead of DIN 3 for ignition detection.
| |
| − |
| |
| − | [[File:5 FMB640 and DAF XF connection wires.png|800px|center|FMB640 and DAF XF connection]]
| |
| − |
| |
| − | * After installation and device configuration of FMB6 (CAN1 should be selected – FMS/TACHO), you can check if the installation is properly made. Turn on the ignition of the vehicle and send SMS command: “tachocheck”. If the response shows: “Can1:111,F2EF”, 111 -means tachograph properly connected, F2EF - or any other value which is not equal to 0000, means FMS data received also.
| |
| − |
| |
| − | [[Category:FMB640 Manual]]
| |
Revision as of 16:33, 21 August 2019
Main Page > EOL Products > FMB640 > FMB640 Manual > How to Install FMB640 on DAF XF
