Difference between revisions of "How to Install FMB640 on DAF XF"
From Wiki Knowledge Base | Teltonika GPS
m |
|||
| (3 intermediate revisions by 3 users not shown) | |||
| Line 1: | Line 1: | ||
| − | [[File: | + | [[File:1 FMB + DAF.png|800px|center]] |
==Installation proccess== | ==Installation proccess== | ||
| Line 5: | Line 5: | ||
* Below is shown main installation location: | * Below is shown main installation location: | ||
| − | [[File:2 Fuse panel cover.png|800px|center|Fuse panel cover]] | + | [[File:2 Fuse panel cover.png|800px|center|Fuse panel cover]]] |
* Carefully unscrew the fuse panel screws and fold the panel down. | * Carefully unscrew the fuse panel screws and fold the panel down. | ||
| − | [[File:3 Fuse panel and screws location.png|800px|center|Fuse panel and screws location]] | + | [[File:3 Fuse panel and screws location.png|800px|center|Fuse panel and screws location]]] |
| − | * Where to find | + | * Where to find main connector? |
| − | [[File:4 Main FMS connector location.png|800px|center|Main FMS connector location]] | + | [[File:4 Main FMS connector location.png|800px|center|Main FMS connector location]]] |
* Connect the wires accordingly. It is recommended to use DIN 1 instead of DIN 3 for ignition detection. | * Connect the wires accordingly. It is recommended to use DIN 1 instead of DIN 3 for ignition detection. | ||
| − | [[File:5 FMB640 and DAF XF connection wires.png|800px|center|FMB640 and DAF XF connection]] | + | [[File:5 FMB640 and DAF XF connection wires.png|800px|center|FMB640 and DAF XF connection]]] |
| − | * After installation and device configuration of FMB6 (CAN1 should be selected – FMS/TACHO), you can check if | + | * After installation and device configuration of FMB6 (CAN1 should be selected – FMS/TACHO), you can check if installation is properly made. Turn on ignition of vehicle and send SMS command: “ tachocheck”. If response shows: “Can1:111,F2EF”, 111 -means tachograph properly connected, F2EF - or any other value which is not equal to 0000, means FMS data received also. |
[[Category:FMB640 Manual]] | [[Category:FMB640 Manual]] | ||
Revision as of 07:29, 22 August 2019
Main Page > EOL Products > FMB640 > FMB640 Manual > How to Install FMB640 on DAF XF
Installation proccess
- Below is shown main installation location:
]
- Carefully unscrew the fuse panel screws and fold the panel down.
]
- Where to find main connector?
]
- Connect the wires accordingly. It is recommended to use DIN 1 instead of DIN 3 for ignition detection.
]
- After installation and device configuration of FMB6 (CAN1 should be selected – FMS/TACHO), you can check if installation is properly made. Turn on ignition of vehicle and send SMS command: “ tachocheck”. If response shows: “Can1:111,F2EF”, 111 -means tachograph properly connected, F2EF - or any other value which is not equal to 0000, means FMS data received also.
