Difference between revisions of "How to Install FMB640 on DAF XF"
From Wiki Knowledge Base | Teltonika GPS
(Blanked the page) |
|||
| (5 intermediate revisions by 4 users not shown) | |||
| Line 1: | Line 1: | ||
| + | [[File:800px-1_FMX640_+_DAF.png|800px|center]] | ||
| + | ==Installation proccess== | ||
| + | |||
| + | * Below is shown main installation location: | ||
| + | |||
| + | [[File:2 Fuse panel cover.png|800px|center|Fuse panel cover]] | ||
| + | |||
| + | * Carefully unscrew the fuse panel screws and fold the panel down. | ||
| + | |||
| + | [[File:3 Fuse panel and screws location.png|800px|center|Fuse panel and screws location]] | ||
| + | |||
| + | * Where to find the main connector? | ||
| + | |||
| + | [[File:4 Main FMS connector location.png|800px|center|Main FMS connector location]] | ||
| + | |||
| + | * Connect the wires accordingly. It is recommended to use DIN 1 instead of DIN 3 for ignition detection. | ||
| + | |||
| + | [[File:5 FMB640 and DAF XF connection wires.png|800px|center|FMB640 and DAF XF connection]] | ||
| + | |||
| + | * After installation and device configuration of FMB6 (CAN1 should be selected – FMS/TACHO), you can check if the installation is properly made. Turn on the ignition of the vehicle and send SMS command: “tachocheck”. If the response shows: “Can1:111,F2EF”, 111 -means tachograph properly connected, F2EF - or any other value which is not equal to 0000, means FMS data received also. | ||
| + | |||
| + | [[Category:FMB640 Manual| 9]] | ||
Latest revision as of 16:27, 7 December 2021
Main Page > EOL Products > FMB640 > FMB640 Manual > How to Install FMB640 on DAF XF
Installation proccess
- Below is shown main installation location:
- Carefully unscrew the fuse panel screws and fold the panel down.
- Where to find the main connector?
- Connect the wires accordingly. It is recommended to use DIN 1 instead of DIN 3 for ignition detection.
- After installation and device configuration of FMB6 (CAN1 should be selected – FMS/TACHO), you can check if the installation is properly made. Turn on the ignition of the vehicle and send SMS command: “tachocheck”. If the response shows: “Can1:111,F2EF”, 111 -means tachograph properly connected, F2EF - or any other value which is not equal to 0000, means FMS data received also.
