|
|
| Line 1: |
Line 1: |
| − | [[File:1_FMB640_and_MB_actros.png|800px|center]]
| |
| | | | |
| − | ==Installation proccess==
| |
| − |
| |
| − | * Below is shown main installation location:
| |
| − |
| |
| − | [[File:2 cable location.png|800px|center|Installation location]]]
| |
| − |
| |
| − | * Main cables, which should be used – twisted pair of violet and white-brown for FMS/CAN and Tachograph connection. Same line is used to read FMS data and to download Tachograph files. Additionally K-line wire for live vehicle data from tachograph is located in same place violet – white wire:
| |
| − |
| |
| − | [[File:3 wires.png|800px|center|Locating FMS and K-Line wires]]
| |
| − |
| |
| − | * Below shown connection of CAN1 pair from FMB6 device to FMS/TACHO line on vehicle and K-line connection to FMB6:
| |
| − |
| |
| − | [[File:4 wire meanings.png|800px|center|3 FMS and K-Line connection to FMB6]]
| |
| − |
| |
| − | * To get proper ressistence on CAN circut, needed to disconnected resistence connector which is near tachograph:
| |
| − |
| |
| − | [[File:5 tacho resistor location.png|800px|center|Resistence connector location]]
| |
| − | <br>
| |
| − | [[File:6 resistor connector.png|800px|center|Resistence connector with attachment]]
| |
| − | <br>
| |
| − | [[File:7 connector removed.png|800px|center|Resistence connector]]
| |
| − | <br>
| |
| − | * Recommended power source and ignition connection wires:
| |
| − | <br>
| |
| − | [[File:8power source and ignition wires.png|800px|center|Power source and ignition wires]]
| |
| − | <br>More detailed view of Ignition connection:<br>
| |
| − | [[File:9 ignition detection wires.png|800px|center|Ignition detection wire]]
| |
| − | <br>
| |
| − | * Recommended place for GNSS antenna:
| |
| − | <br>
| |
| − | [[File:10 gnss antena location.png|800px|center|antenna prefered installation location]]
| |
| − | <br>
| |
| − | [[File:11 installed gnss antena.png|800px|center|Installed GNSS antenna]]
| |
| − |
| |
| − | <br>
| |
| − | After installation and device configuration of FMB6 (CAN1 should be seletected – FMS/TACHO), you can check if instalation is properly made. Turn on ignition of vehicle and send sms command: “ tachocheck”. If response shows: “Can1:111,F2EF”, 111 -means tachograph properly connected, F2EF - or any other value which is not equal to 0000, means FMS data received also.
| |
| − |
| |
| − | [[Category:FMB640 Manual]]
| |
