How to connect FMB640 with FMS Cable

From Wiki Knowledge Base | Teltonika GPS
Main Page > EOL Products > FMB640 > FMB640 Manual > How to connect FMB640 with FMS Cable

Description

Cable is a standardized heavy duty vehicle FMS 12-pin connector, for connecting FMX640 with one plug and receiving vehicle information through CAN line and K-line, along with powering the device and getting Ignition detection. This ensures easier connection and does not violate the factory warranty.

Fms-cable-scheme.jpg

FMS Plug Location

Even though the FMS cable is standardized cable – its placement in the vehicle might differ depending on manufacturer and depending on vehicle trim level.

We were able to identify the most common places for the FMS plug – refer to the examples bellow:

  1. Behind the Fuse panel on passenger side – for Example SCANIA S/R/G/P Euro6 Series: Scania R-series 1.3.png
  2. Near the Fuse panel on passenger side – for example DAF XF Euro6: DAF XF 1.3.png
  3. Behind the Radio on lower deck – for example Volvo FH Euro5 and Renault T Euro6: Volvo FH 1.3.png
  4. Behind the Tachograph on upper deck – for example Mercedes Actros MP5 Euro6: Mercedes Actros 1.3.png


Remote Data Download (RDD) via FMS

When RDD (Remote Data Download) signal available on FMS.

Applies to:

  • DAF CF - LF - XF
  • IVECO Stralis I / II/ Hi-Way
  • Renault D / Magnum DXI & E-TECH / Midlum DXI / Premium DXI / Renault T-K-C
  • Volvo FH - FM - FL

If the RDD signal is available on the FMS interface, no additional connection is required. In this case, the CANx LOW and HIGH wires from the FMx640 are connected to PIN 6 and 9 on the FMS connector. Additionally, PIN 10 can be used for ignition detection using DIN1 wire.

central central



For the following vehicles regarding the RDD, please contact the manufacturer:

  • MAN TGX - TGA - TGL - TGM
  • Mercedes Actros / Antos / Atego / Arocs / Axor II
  • Scania R - P - G - S